基于等切共轭的弧齿锥齿轮差曲面建立与解析

对弧齿锥齿轮提出了一种新的共轭求解方法，来更方便地求解共轭小轮的齿面方程，在此基础上进行了齿面接触分析。在分析过程中提出了一种新的ease-off差曲面计算方法，即用对应点的转角误差替代直线误差进行差曲面求解，使得传动误差解析、齿面修形量的确定更为直观和准确。提取了ease-off曲面上的差曲线，以方便地确定出接触路径和边缘接触点。根据全程差曲线得到了齿面接触印痕分布情况。     

基于材料力学性能的最低设计金属温度曲线分析

铁素体钢在低温条件下存在明显的韧脆转变现象。为防止脆断事故的发生,需要确定铁素体钢制压力容器的最低使用温度。针对ASME中的A^D四条冲击豁免曲线,对应地选取了4种材料,基于材料实际的屈服强度和参考温度,按照ASME中豁免曲线的计算方法,计算得到4种材料的最低设计金属温度曲线,并与对应的A^D曲线对比,定量地分析ASME中豁免曲线的保守性。结果表明,ASME中的豁免曲线相对于材料自身的最低设计金属温度曲线保守性较大;韧性相近的材料被划分到不同的豁免曲线,使得韧性富裕量差异较大,对于某些材料,其断裂韧性被低估。     

Application of dielectric barrier discharge (DBD) plasma packed with glass and ceramic pellets for SO2 removal at ambient temperature: optimization and modeling using response surface methodology

Air pollution is a major health problem in developing countries and has adverse effects on human health and the environment. Non-thermal plasma is an effective air pollution treatment technology. In this research, the performance of a dielectric barrier discharge (DBD) plasma reactor packed with glass and ceramic pellets was evaluated in the removal of SO₂ as a major air pollutant from air in ambient temperature. The response surface methodology was used to evaluate the effect of three key parameters (concentration of gas, gas flow rate, and voltage) as well as their simultaneous effects and interactions on the SO₂ removal process. Reduced cubic models were derived to predict the SO₂ removal efficiency (RE) and energy yield (EY). Analysis of variance results showed that the packed-bed reactors (PBRs) studied were more energy efficient and had a high SO₂ RE which was at least four times more than that of the non-packed reactor. Moreover, the results showed that the performance of ceramic pellets was better than that of glass pellets in PBRs. This may be due to the porous surface of ceramic pellets which allows the formation of microdischarges in the fine cavities of a porous surface when placed in a plasma discharge zone. The maximum SO₂ RE and EY were obtained at 94% and 0.81 g kWh⁻¹, respectively under the optimal conditions of a concentration of gas of 750 ppm, a gas flow rate of 2 l min⁻¹, and a voltage of 18 kV, which were achieved by the DBD plasma packed with ceramic pellets. Finally, the results of the model's predictions and the experiments showed good agreement.     

高温气冷堆舱室抗商用飞机撞击的耦合数值分析

本文建立了大型商用飞机撞击典型高温气冷堆核电站反应堆舱室的非线性有限元模型，计算中混凝土舱室直接采用工程用钢筋混凝土的损伤塑性本构模型，飞机结构采用Johnson-Cook本构模型。对飞机高速撞击高温气冷堆核电站反应堆舱室非线性撞击过程进行模拟计算，得出正面和侧面撞击条件下的撞击载荷曲线、撞击位移云图、反应堆舱室混凝土破坏情况等结果。评估表明，反应堆舱室结构在撞击条件下的整体损伤微小，可为保护内部关键设备提供重要的屏障功能。     

川西彭州地区雷口坡组潮坪相薄储层辨识机理研究

川西彭州地区三叠系雷口坡组雷四上亚段潮坪相薄储层识别难度极大。围绕如何从复合地震强反射中区分并识别上、下两套储层面临的地球物理难题,采用先“分”后“合”的研究思路,基于实际地层结构及不同储层叠加样式建立正演模型,利用全波场波动方程正演模拟技术,剖析了不同主频条件下薄储层的地震响应特征,通过波形差异化分析,从复合地震响应中“剥离”出了两套储层所引起的地震响应特征及变化规律,明确了两套储层在不同频带下的地震识别标志和识别方法,为该区强反射界面干扰下两套薄互层储层辨识机理分析及精准预测奠定了基础。基于不同频带下薄储层辨识机理的分析结果,定性预测了薄储层平面展布,提出了深层潮坪相薄储层识别和预测难题的解决方案,为该区地震资料品质评价、面向薄储层的地震采集技术设计、地震资料处理及薄储层预测提供了依据和指导。     

Study of equivalent efficiency calibration method for radioactive gas source measured on HPGe detectors

ABSTRACT

In view of the complexity of current detection efficiency calibration of radioactive gas sources, a method using solid planar sources to be equivalent to gas sources was studied. For the 50 mL gas source box, an optimal equivalent scheme was selected by Monte Carlo Simulations. Then, the full-energy-peak efficiency curve of gas sources at the measurement position of 25 cm, with source-to-detector distance of 25 cm, was fitted by measuring solid planar sources with known activity. To verify the accuracy of the efficiency curve, ⁴¹Ar, ¹³³Xe and ⁸⁷Kr gases were produced and determined by length-compensated method. Then, their full-energy-peak efficiencies at 25 cm position away from the detector were directly calibrated. The percentage efficiency deviations between interpolation from the efficiency curve and direct calibration are all less than 2.5%, which proves the accuracy of the equivalent method. This calibration method is a general one and can be also used for some other radioactive sample measurements, such as non-destructive analysis of gaseous fission product samples with a suitable source-to-detector distance.     

响应面法优化制备LDHs-CRMA复合改性沥青及其表征

采用熔融共混法，以克拉玛依90^#沥青为原料，Mg-Al水滑石(LDHs)与废橡胶粉(CR)作为改性剂，制备了具有抗紫外老化性能的水滑石/废胶粉复合改性沥青(LDHs/CRMA)，并对其软化点、针入度指数(PI)、延度进行了测试。通过Hassan数学方法将三个指标“归一化”得到总评“归一值”，采用响应面分析法建立总评“归一值”与各因素之间的Box-Behnken数学模型，得到了LDHs/CRMA的最优制备工艺条件为：剪切温度173℃、剪切时间89 min、剪切速率3500 r/min。通过紫外老化模拟实验对复合改性沥青的抗老化性能进行了评价，结果表明，引入水滑石可以减少沥青老化过程中含氧官能团的产生，抗紫外老化性能得到了明显提高。     

Band-gap-tunable CeO2 nanoparticles for room-temperature NH3 gas sensors

NH₃ is a type of essential raw material but harmful. In this work, CeO₂ nanoparticles were synthesized as NH₃ gas sensing materials by simple hydrothermal method. The response time of the sensor is extremely fast (3 s) towards 500 ppm NH₃ with the response of 22.0 at room temperature. The concentration of NH₃ and its response show well-matched functional relationship in the range of 0.5 ppm-1000 ppm. The selectivity of NH₃ is distinct and the detection limit is as low as 500 ppb. The excellent NH₃ gas sensing performance may be attributed to more oxygen vacancies and narrower band gap. This CeO₂ nanoparticles-based gas sensor could be reliable to detect and monitor NH₃ at room temperature.     

Optimising clarification of carrot juice by bacterial crude pectinase

This study was undertaken to search for potential use of crude bacterial pectinase enzyme produced from Bacillus subtilis grown on hazelnut shell hydrolysate in clarification of carrot juice and to optimize the enzyme load, pH and time using the Box–Behnken response surface methodology (RSM). The carrot juice was treated with the crude pectinase enzyme (5.60 U mL^?1) at different concentrations (0.1–0.5%), pH (4–7), and time (2–6 h). The obtained enzyme was also compared with commercial fungal pectinase at identical conditions. RSM provided optimal clarification conditions of 0.5% (w/v) enzyme load, 7.0 pH, and 6 h of time estimating 100% clarity, whose experimental counterpart was 94.47 ± 0.01%. High values of coefficient of determination (R² = 0.9631), predicted R² (0.8989) and insignificant lack‐of‐fit (0.12) also showed that the model was successful in predicting % clarity for various combinations. This study also indicated that crude bacterial pectinase providing about 95% clarity is superior to commercial fungal pectinase, which gave 78% clarity under tested conditions, in terms of clarification ability for carrot juice.